subject
Engineering, 12.12.2019 06:31 seolizyl

The settlement analysis for a proposed structure indicates that the underlying clay layer will settle 7.5 cm in 3 years, and that ultimately the total settlement will be about 32 cm. however, this analysis is based on the clay layer being doubly drained. it is suspected that there may be no drainage at the bottom of the layer.

answer the following questions based on single drainage only, assuming cv = 1.5 x 10-4 cm 2 /s for both single and double drainage.

(a) how will the total settlement change from the double to the single drainage case?

(b) how long will it take for 7.5 cm of settlement to occur if there is only single

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
question
Engineering, 04.07.2019 19:10
The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false
Answers: 2
question
Engineering, 04.07.2019 19:10
What is the major difference between thermoplastics and thermosetting plastics from the polymerization structure point of view?
Answers: 2
You know the right answer?
The settlement analysis for a proposed structure indicates that the underlying clay layer will settl...
Questions
Questions on the website: 13722359