Engineering, 12.12.2019 06:31 chrischris1

Aservomechanism position control has the plant transfer function g(s) = 10 s(s + 1)(s + 10). you are to design a compensation transfer function d(s) in a unit feedback configuration to meet the following closed-loop specifications: • the response to a reference unit step input should have 16% overshoot (or less) and 0.4 sec rise time (or less). • the steady-state error to a reference unit ramp input must be less than 0.05. (a) design a lead compensator that will cause the system to meet the dynamic response specifications, ignoring the error requirement.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

Answer

You know the right answer?

Aservomechanism position control has the plant transfer function g(s) = 10 s(s + 1)(s + 10). you are...

Questions