Engineering, 17.12.2019 21:31 jakeyywashere

Anew cat6 cable run and keystone jack were installed for a workstation that was moved from the sales department to the shipping department. since the move, the user has been complaining of slow transfer speeds on both internet and local network communications. the technician ran a test and is viewing the following output on the tester. which of the following is the most likely reason for the sluggish network speeds?

a. the cable run exceeds the specifications for ethernet over twisted pair
b. the nic in the workstation is statically set to 10 mbps/half-duplex
c. the network switch port is statically set to 10 mbps/half-duplex
d. the isp is experiencing issues with its service to this customer

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Vibration monitoring this technique uses the noise or vibration created by mechanical equipment and in seme cases by plant systems to detemine their actual condtion. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.

Answers: 1

Answer

You know the right answer?

Anew cat6 cable run and keystone jack were installed for a workstation that was moved from the sales...

Questions