subject
Engineering, 20.12.2019 01:31 duyphan

Here is a series of addresses in hexadecimal: 20(w), 3c(r), 10(r), 16(w), 20(r), 04(w), 28(r), 6(r), 10(w), 17(w)assume a lru replacement algorithm. for the four caches in problem 1, draw each cache as it would appear at the end of the series of references. include the valid bit, dirty bit, and tag. show the contents of the memory block using the byte address range such as m[20-23] for the word with address 22.here is problem 1 for reference. i need some with part d (cache d) in reference to the question above ( i have already solved question 1.1. there are 4 caches with the organization and block size as indicated below. all caches hold 128 words where each word is 4 bytes. assuming a 32-bit address. a. a direct-mapped cache with block size of 16 wordsb. 2-way set-associative cache with block size of 8 words c. 4-way set-associative cache with block size of 4 words d. a fully associative cache with block size of 32 words.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
question
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
question
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
question
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
You know the right answer?
Here is a series of addresses in hexadecimal: 20(w), 3c(r), 10(r), 16(w), 20(r), 04(w), 28(r), 6(r),...
Questions
question
English, 22.02.2020 02:54
Questions on the website: 13722360