Engineering, 20.12.2019 03:31 ladya1613

Atorpedo 8 m below the surface in 20°c seawater cavitates at a speed of 21 m/s when atmospheric pressure is 101 kpa. consider reynolds-number and froude-number effects are negligible. for seawater at 20°c, take rho = 1025 kg/m3 and pv = 2337 pa.

at what speed will the torpedo cavitate when running at a depth of 38 m? round the answer to one decimal place.

the speed at which the torpedo will cavitate is= m/s

at what depth should it be to avoid cavitation at 32 m/s? round the answer to one decimal place.

the depth at which the torpedo should be to avoid cavitation is= m.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 08:10

Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Determine the time of the day and month of the year at which the peak sensible cooling load occurs for a top floor, north-eastern corner room of an office building in durban for the following conditions: floor area: 8 x 8 x 3 m east and north walls: 115 mm face brick (outside), 20 mm air space, 115 mm ordinary brick (inside) with 15 mm plaster roof construction: suspended plasterboard ceiling, 450 mm air space, 150 mm concrete, 75mm screed, waterproofing no heat transfer across other surfaces window area 3x 1,5 m high in north wall only. ordinary glass with venetian blinds. lights and occupants : from 07: 00 to 18: 00 average light density: 25 w/m2 number of occupants : 5 seated, light office work room temperature 24°c

Answers: 3

Answer

Engineering, 06.07.2019 03:20

1kg of water contained in a piston-cylinder assembly undergoes two processes in series from an initial state where the pressure is 3.0 bar and the temperature is 150°c process 1-2: the water is compressed isothermally to a volume of 0.25 m^3 with 120 kj of work being done to the system. process 2-3: the water is heated at constant volume to a final pressure of 10 bar. a. find the change in internal energy for the system. b. calculate the amount of heat transferred, in kj. c. sketch both processes on a t-v diagram. (196.33 kj/kg, 76.33 kj)

Answers: 1

Answer

Engineering, 06.07.2019 04:10

Aheat pump with refrigerant-134a as the working fluid is used to keep a space at 25°c by absorbing heat from geothermal water that enters the evaporator at 500c at a rate of 0.065 kg/s and leaves at 40°c. the refrigerant enters the evaporator at 20°c with a quality of 23 percent and leaves at the inlet pressure as saturated vapor. the refrigerant loses 300 w of heat to the surroundings as it flows through the compressor and the refrigerant leaves the compressor at 1.4 mpa at the same entropy as the inlet. determine: (a) the degrees of subcooling of the refrigerant in the condenser, b)-the mass flow rate of the refrigerant . (c) the heating load and the cop of the pump, and d)-the theoretical minimum power input to the compressor for the same heating load.

Answers: 3

Answer

You know the right answer?

Atorpedo 8 m below the surface in 20°c seawater cavitates at a speed of 21 m/s when atmospheric pres...

Questions