Engineering, 20.12.2019 23:31 taleiayarbough2940

Amechanical engineer wishes to compare strength properties of steel beams with similar beams made with a particular alloy. the same number of beams, n, of each type will be tested. each beam will be set in a horizontal position with a support on each end, a force of 2500 lb will be applied at the center, and the deflection will be measured. from past experience with such beams, the engineer is willing to assume that the true standard deviation of deflection for both types of beam is 0.06 in. because the alloy is more expensive, the engineer wishes to test at level 0.01 whether it has smaller average deflection than the steel beam. what value of n is appropriate if the desired type ii error probability is 0.05 when the difference in true average deflection favors the alloy by 0.05 in.? (round your answer up to the next whole number.) n = beams

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

Answer

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.

Answers: 3

Answer

You know the right answer?

Amechanical engineer wishes to compare strength properties of steel beams with similar beams made wi...

Questions