Engineering, 25.12.2019 18:31 dianereyes7475

The bit currently in use has three 12/32-in. nozzles. the driller has recorded that when the 10- lbm/gal mud is pumped at a rate of 500-gal/min, a pump pressure of 3,000 psig is observed, and when the pump is slowed to a rate of 250-gal/min, a pump pressure of 800 psi is observed. the pump is rated at 1,000 hp and has an overall efficiency of 0.9. the minimum flow rate to lift the cuttings is 240- gal/min. the maximum allowable surface pressure is 3,000 psi.

a) determine the proper pump operating conditions and bit nozzle sizes for maximum bit horsepower for the next bit run.
b) what bit horsepower will be obtained at the conditions selected?
c) what impact force will be obtained at the conditions selected?
d) what nozzle velocity will be obtained at the conditions selected? e) plot the graphical representation correspondi

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody

Answers: 2

Answer

You know the right answer?

The bit currently in use has three 12/32-in. nozzles. the driller has recorded that when the 10- lbm...

Questions