Engineering, 08.01.2020 17:31 kayvontay4
What should be used to feed material into a machine? a. joy stick b. push stick c. your feet d. your hands
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Vibration monitoring this technique uses the noise or vibration created by mechanical equipment and in seme cases by plant systems to detemine their actual condtion. a)- true b)- false
Answers: 2
Engineering, 04.07.2019 19:10
What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.
Answers: 1
You know the right answer?
What should be used to feed material into a machine? a. joy stick b. push stick c. your feet d. you...
Questions
Mathematics, 30.03.2021 03:40
Mathematics, 30.03.2021 03:40
Mathematics, 30.03.2021 03:40
World Languages, 30.03.2021 03:40
Mathematics, 30.03.2021 03:40
Mathematics, 30.03.2021 03:40
Computers and Technology, 30.03.2021 03:40
Mathematics, 30.03.2021 03:40
Mathematics, 30.03.2021 03:40
Mathematics, 30.03.2021 03:40
Mathematics, 30.03.2021 03:40
