Engineering, 23.01.2020 18:31 joshuabm42407

The rigid bar cde is attached to a pin support at e and rests on the 30 mm diameter brass cylinder bd. a 22 mm diameter steel rod ac passes through a hole in the bar and is secured by a nut which is snugly fitted when the temperature of the entire assembly is 20oc. the temperature of the brass cylinder is then raised to 50oc while the steel rod remains at 20oc.
assuming that no stresses were present before the temperature change,
determine the stress in the cylinder.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information

Answers: 3

Answer

Engineering, 04.07.2019 18:10

An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Water vapor initially at 10 bar and 400 °c is contained within a piston-cylinder assembly. the water lost heat to the surrounding according to isochoric (iso-volumetric) process until its temperature is 150 °c. the water is then condensed isothermally to saturated liquid. for the water as a system, calculate the work in kj/kg

Answers: 2

Answer

You know the right answer?

The rigid bar cde is attached to a pin support at e and rests on the 30 mm diameter brass cylinder b...

Questions