Engineering, 24.01.2020 22:31 theojw
Two metallic terminals protrude from a device. the terminal on the left is the positive reference for a voltage called vx (the other terminal is the negative reference). the terminal on the right is the positive reference for a voltage called vy (the other terminal being the negative reference). if it takes 1 mj of energy to push a single electron into the left terminal, determine the voltages vx and vy.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:20
The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?
Answers: 3
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
Engineering, 04.07.2019 19:10
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
Engineering, 04.07.2019 19:20
Acompressor compresses a gas, a pump compresses a liquid. for a given pressure ratio, why does it take more work to compress a gas in a compressor than a liquid in a pump? a)- for a given pressure ratio the average specific volume for a gas is much higher than the average specific volume for a liquid. b)- there is no difference. the only difference is the amount of heat generated (not work) c)- for a given pressure ratio the average volurge for a gas is much higher than the average volume for a liquid. d)-there is no difference
Answers: 3
You know the right answer?
Two metallic terminals protrude from a device. the terminal on the left is the positive reference fo...
Questions
Geography, 20.07.2019 13:30
History, 20.07.2019 13:30
Arts, 20.07.2019 13:30
Biology, 20.07.2019 13:30
English, 20.07.2019 13:30
Social Studies, 20.07.2019 13:30
