Engineering, 29.01.2020 05:40 angelina6836
Asteel plate is to be attached to a support with three bolts. the plate is 50 mm wide and 11.2 mm thick and the yield strength of the steel is 250 mpa. the ultimate bearing strength of the bolts is 540 mpa. a factor of safety of 1.67 with respect to yield is required for the plate. a factor of safety of 4.0 with respect to the ultimate bearing strength is required for the bolts. determine the minimum bolt diameter required to develop the full strength of the plate. (note: consider only the gross cross-sectional area of the plate)
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:20
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
Engineering, 04.07.2019 18:20
Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]
Answers: 1
Engineering, 04.07.2019 19:10
Plan an experiment to measure the surface tension of a liquid similar to water. if necessary, review the ncfmf video surface tension for ideas. which method would be most suitable for use in an undergraduate laboratory? what experimental precision could be expected?
Answers: 2
You know the right answer?
Asteel plate is to be attached to a support with three bolts. the plate is 50 mm wide and 11.2 mm th...
Questions
Mathematics, 14.12.2020 19:20
Mathematics, 14.12.2020 19:20
Biology, 14.12.2020 19:20
Mathematics, 14.12.2020 19:20
History, 14.12.2020 19:20
Mathematics, 14.12.2020 19:20
Computers and Technology, 14.12.2020 19:20
Mathematics, 14.12.2020 19:20
Social Studies, 14.12.2020 19:20
