Engineering, 11.02.2020 03:42 pgfrkypory2107

Problem 7 (15 points): The two input signals of an instrumentation amplifier (which has an 80 dB CMRR) are, 1 = 2 cos 8 + + 0.1 cos 2 2491 + theta 2 = 2 cos 8 + − 0.1 cos 2 2491 + theta The difference mode component of the signal is the desired signal while the common mode signal is considered noise. a) [5 points] Find the SNR in dB at the input of the IA. b) [5 points] Find the SNR in dB at the output of the IA. c) [5 points] If the output of the IA is connected to a filter with the transfer function, H = 3 + 3 Find the SNR in dB at the output of the filter.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Select any two (2) areas of applications of chain-drive. (clo4) a)-permanent lubrication necessary b)-hydraulic forklift truck operation c)-rigging and heavy moving materials d)-relatively high maintenance costs e)-costlier than belt drives

Answers: 2

Answer

You know the right answer?

Problem 7 (15 points): The two input signals of an instrumentation amplifier (which has an 80 dB CMR...

Questions