Given the dimensions in the figure above, and the following data:
Water Temperature: 21....
Engineering, 11.02.2020 20:37 Lscifa
Given the dimensions in the figure above, and the following data:
Water Temperature: 21.6 degrees celsius
(Depth = Depth of the water in each trial and there was seven trials)
(Mass = Mass of each trial needed to equalize the beam)
1. Compare the theoretical force with the measured force. The measured force is obtained by setting the summation of moments about the pivot point equals to zero. However, the calculation involved the assumption that the center of pressure can be calculated from the equation provided below.
2. Also confirm that if depth is less than 100mm, the center of pressure is located h/3 from the bottom of the quadrant(h=depth of water). Explain why the center of pressure is NOT located at a distance h/3 from the bottom of the quadrant for depths greater than 100mm.
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
Engineering, 04.07.2019 18:10
Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false
Answers: 3
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 19:20
Asimple speed reducer is composed of 2 spur gears. the pinion gear has a pitch diameter of 0.75" and 36 teeth while the driven gear has a pitch diameter of 4.0" and 192 teeth. a)-what is the diametral pitch of each gear? b)-if an electric motor rotating ccw at 3000 rpm is coupled to the pinion, what is the rotational speed of the driven gear? c)-if the torque delivered to the pinion is 1 n-m, what is the torque on the driven gear? d)-what is the power transmitted by the gear train?
Answers: 1
You know the right answer?
Questions
Mathematics, 07.04.2020 16:19
