subject
Engineering, 12.02.2020 04:48 kate460

A pitot tube is mounted in the test section of a low-speed open-circuit subsonic wind tunnel. Air is flowing through the test section at 45 m/s. The air pressure in the test section is approximately that at the University of Denver 83,020 Pa and the Temperature is 298 K (room temperature).
a) Calculate the inlet velocity into the wind tunnel assuming that the contraction ratio of the wind tunnel is 10 to 1.b) Calculate the pressure measured by the pitot tube in the test section (i. e. the stagnation pressure).c) If static ports were used in each section of the wind tunnel (between the converging inlet section and test section), what would be the measured differential pressure?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
question
Engineering, 04.07.2019 18:10
Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.
Answers: 2
question
Engineering, 04.07.2019 18:20
For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.
Answers: 1
question
Engineering, 06.07.2019 02:30
A12 mm diameter shaft runs in a plain cylindrical bush 30 mm long that is located in an 18 mm diameter hole in a housing. the shaft-inner bush fit is h8 f and the outer bush-housing fit is h7-p6. make a fully cimensioned sketch of the bush with tolerances. find the maximum and minimum clearance or interference for both fits on the inner and outer diameters of the bush
Answers: 3
You know the right answer?
A pitot tube is mounted in the test section of a low-speed open-circuit subsonic wind tunnel. Air is...
Questions
question
Mathematics, 26.02.2020 19:48
Questions on the website: 13722363