subject
Engineering, 13.02.2020 18:25 munekalove69ounxwv

The aircraft A with radar detection equipment is flying horizontally at an altitude of 10.3 km and is increasing its speed at the rate of 1.27 m/s each second. Its radar locks onto an aircraft B flying in the same direction and in the same vertical plane at an altitude of 17.4 km. If A has a speed of 860 km/h at the instant when = 23Β°, determine the values of r and O at this same instant if B has a constant speed of 1570 km/h.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
question
Engineering, 04.07.2019 18:10
The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false
Answers: 2
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 06.07.2019 02:30
1in2 processor chip can be modelled as an isothermal plane wall of silicon, isothermal on both sides. the power input to the bottom of the plane wall, or the processing power of the chip, often called the thermal design power (tdp), is 100w. assume the periphery is adiabatic. the silicon is 400 microns thick. the temperature at the junction, or in this case on the bottom of the isothermal plane wall, is 85Β°c. what is the top surface temperature, assuming that the only mode of heat transfer is conduction
Answers: 1
You know the right answer?
The aircraft A with radar detection equipment is flying horizontally at an altitude of 10.3 km and i...
Questions
question
Mathematics, 21.09.2020 21:01
question
Chemistry, 21.09.2020 21:01
question
English, 21.09.2020 21:01
question
English, 21.09.2020 21:01
question
History, 21.09.2020 21:01
question
Mathematics, 21.09.2020 21:01
Questions on the website: 13722359