Engineering, 13.02.2020 17:51 alegora78
The actual distance between two marks used at a university for standardizing tapes is 100.03 ft. When a certain tape was held along this line, the surveyor, thinking that the distance between the marks was 100.00 ft, observed the tape was 99.94 ft long. What is correct length of the tape?
Answers: 1
Engineering, 03.07.2019 14:10
Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.
Answers: 3
Engineering, 04.07.2019 18:10
The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false
Answers: 2
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
The actual distance between two marks used at a university for standardizing tapes is 100.03 ft. Whe...
Social Studies, 14.08.2021 14:00
Biology, 14.08.2021 14:00
Computers and Technology, 14.08.2021 14:00
English, 14.08.2021 14:00
Mathematics, 14.08.2021 14:00
Health, 14.08.2021 14:00
Mathematics, 14.08.2021 14:00
Chemistry, 14.08.2021 14:00
Social Studies, 14.08.2021 14:00
Mathematics, 14.08.2021 14:00
Computers and Technology, 14.08.2021 14:00
Mathematics, 14.08.2021 14:00