Engineering, 14.02.2020 05:25 jaydahh4059
If you haven’t already done so, enter the commands in the example above to generate the permutation matrix E defined in (2) (you can suppress this matrix). Generate a 5 × 5 matrix A with integer entries using the command A = floor(10*rand(5))
(a) Compute the product EA and compare the answer with the matrix A. How are the two matrices related? Describe the effect on A of left multiplication by the permutation matrix E. Be specific! Compute the product AE and compare the answer with the matrix A. How are the two matrices related? Describe the effect on A of right multiplication by the permutation matrix E. Be specific!
(b) Compute E−1 and ET (recall that ET is computed in MATLAB with the command E’), and observe that they are also permutation matrices. What else do you observe about E−1 and ET ?
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false
Answers: 3
Engineering, 04.07.2019 18:10
Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?
Answers: 1
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
You know the right answer?
If you haven’t already done so, enter the commands in the example above to generate the permutation...
Questions
Computers and Technology, 26.11.2019 18:31
