subject
Engineering, 15.02.2020 00:41 kovachb11

Complete the following two statements regarding quantum-mechanical concepts associated with the Bohr model of the atom and refinements that resulted from the wave-mechanical atomic model. " Two important quantum-mechanical concepts associated with the Bohr model of the atom are that electrons are particles moving in Enter your answer for the missing word between words "moving in" and "orbitals" in accordance to the question statement discrete orbitals, and electron energy is quantized into Enter your answer for the missing word after words "quantized in" in accordance to the question statement levels . (b) Two important refinements resulting from the wave-mechanical atomic model are that the electron position is described in terms of a Enter your answer for the missing words after words "in terms of a" in accordance to the question statement electron cloud , and electron energy is quantized into both shells and subshells--each electron is characterized by Enter your answer for the missing word after words "is characterized by" in accordance to the question statement quantum numbers."

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
question
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
You know the right answer?
Complete the following two statements regarding quantum-mechanical concepts associated with the Bohr...
Questions
question
Mathematics, 23.07.2019 18:10
Questions on the website: 13722361