Engineering, 17.02.2020 17:20 xxtonixwilsonxx
Which of the following is NOT correct regarding the factor of safety? a. The greater the factor of safety, the safer the system (with respect to failure). b. The factor of safety is a ratio of the allowable load to the failure load. c. The factor of safety is used to account for uncertainties resulting from the variability of both the material's properties and the loading that must be supported. d. The factor of safety used in the design of aircraft or space vehicle components may be close to 1.
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Engineering, 04.07.2019 18:20
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
Engineering, 04.07.2019 18:20
Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t
Answers: 3
You know the right answer?
Which of the following is NOT correct regarding the factor of safety? a. The greater the factor of s...
Questions
History, 24.03.2021 20:30
Mathematics, 24.03.2021 20:30
English, 24.03.2021 20:30
History, 24.03.2021 20:30
Mathematics, 24.03.2021 20:30
Biology, 24.03.2021 20:30
Biology, 24.03.2021 20:30
Mathematics, 24.03.2021 20:30
History, 24.03.2021 20:30
Computers and Technology, 24.03.2021 20:30
Social Studies, 24.03.2021 20:30
