subject
Engineering, 17.02.2020 18:17 Jorjalilli8786

Consider the internal structure of the pseudo-CPU augmented with a single-port register file (i. e., only one register value can be read at a time) containing 32 8-bit registers (R31-R0) and a carry bit (C-bit), which is set/reset after each arithmetic operation. Suppose the pseudo-CPU can be used to implement the AVR instruction ADIW ZH:ZL,32 (Add immediate to word). ADIW is a 16-bit instruction, where the upper byte represents the opcode and the lower byte represents an immediate value, i. e., "32" (do not worry about the fact that the actual format is slightly different). Give the sequence of microoperations required to Fetch and Execute the ADIW instruction.

Your solutions should result in exactly 5 cycles for the fetch cycle and 6 cycles for the execute cycle. Assume the memory is organized into addressable bytes (i. e., each memory word is a byte), MDR, IR, and AC registers are 8-bit wide, and PC and MAR registers are 16-bit wide. Also, assume Internal Data Bus is 16-bit wide and thus can handle 8-bit or 16-bit (as well as portion of 8-bit or 16-bit) transfers in one microoperation and only PC and AC have the capability to increment itself.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false
Answers: 1
question
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
question
Engineering, 04.07.2019 18:20
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
You know the right answer?
Consider the internal structure of the pseudo-CPU augmented with a single-port register file (i. e.,...
Questions
Questions on the website: 13722360