Engineering, 17.02.2020 23:04 bobtothemaxthe1st

Assume that a single plate of cockpit window glass had a width of 300 mm at 20 °C and that at that temperature there was a clearance all around the glass of 0.5 mm. The lowest temperature in which the airplane needed to be able to survive was –30 °C (very extreme winter conditions at JFK airport). The highest temperature was 153 °C (temperature at the absolute maximum speed of Concorde, Mach 2.2).

i. Find the maximum and minimum sizes of the glass–aluminum gap that would occur in use.
ii. Assume that the sealant was silicone rubber (thermal coefficient of Silicone Rubber = 250x10^-6/K) and that it was under zero stress at 20 °C. What would be the maximum tensile and compressive stresses experienced by the sealant in operation?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure

Answers: 2

Answer

You know the right answer?

Assume that a single plate of cockpit window glass had a width of 300 mm at 20 °C and that at that t...

Questions