Engineering, 18.02.2020 02:30 emmie50

One of the National Academy of Engineering Grand Challenges for Engineering is Develop Carbon Sequestration Methods. The NAE defines carbon sequestration as "capturing the carbon dioxide produced by burning fossil fuels and storing it safely away from the atmosphere." The most promising storage location is underground, possibly in sedimentary brine formations. You are assigned to develop instrumentation to measure the properties of a brine formation, located 800 meters [m] deep.
Assume the instruments will feel an equivalent amount of pressure to the amount of hydrostatic pressure felt at the bottom of an 800-meter [m] high column of brine, with a specific gravity of 1.35.
1. To what hydrostatic pressure, in units of atmospheres [atm], must the instrumentation be built to withstand?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

Answer

You know the right answer?

One of the National Academy of Engineering Grand Challenges for Engineering is Develop Carbon Seques...

Questions