Engineering, 19.02.2020 01:03 vannitling12p4w44f
Given the following neckdown in a pipe carrying water (P = 1000 kg/m3) .Your aim is to find the force on the joint.
(a)Draw a Control Volume for this problem.
(b)Find the velocity at point (2)?
(c)Find the pressure at point (2)?
(d)What force does the fluid experience?
(e)What force does the joint experience?
Answers: 2
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
Burgers vector is generally parallel to the dislocation line. a)-true b)-false
Answers: 2
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
Given the following neckdown in a pipe carrying water (P = 1000 kg/m3) .Your aim is to find the forc...
SAT, 08.12.2021 18:20
Mathematics, 08.12.2021 18:20
Mathematics, 08.12.2021 18:20
Mathematics, 08.12.2021 18:20
Computers and Technology, 08.12.2021 18:20
Mathematics, 08.12.2021 18:20