Engineering, 21.02.2020 06:10 hudaalkhatib27
7075-T6 Al has a tensile yield strength of σY=450 MPa. A circular tube of 7075-T6 Al supports an axial load of 60 kN in tension and a torque of 1.0 kN-m. The average diameter of the tube is 50.0 mm. Use the von Mises yield criterion.(a)What is the safety factor against yielding if the wall thickness is 2.0 mm? (1.5)(b)What value of thickness with the same diameter would provide a safety factor of 2.0 against yielding? (2.6 mm)
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 14:10
Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.
Answers: 2
Engineering, 04.07.2019 08:10
Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed
Answers: 1
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
You know the right answer?
7075-T6 Al has a tensile yield strength of σY=450 MPa. A circular tube of 7075-T6 Al supports an axi...
Questions
Mathematics, 22.03.2021 23:20
Chemistry, 22.03.2021 23:20
Spanish, 22.03.2021 23:20
Mathematics, 22.03.2021 23:20
Mathematics, 22.03.2021 23:20
Mathematics, 22.03.2021 23:20
Computers and Technology, 22.03.2021 23:20
