Engineering, 21.02.2020 06:23 jdto8

The homogeneous, reversible, exothermic, liquid phase reaction: A근R Is being carried out in a reactor system consisting of an ideal PFR followed by an ideal CSTR. The volume of the PFR is 75,000 L, and the volume of the CSTR is 150,000 L. The PFR operates at 150 °C, and the CSTR operates at 125 °C. The volumetric flow rate entering the PFR is 55,000 L/h, the concentration of A in this stream is 6.5 M, and the concentration of R is zero. The reaction is first order in both directions. The rate constant of the forward reaction at 150 °C is 1.28 h and the equilibrium constant based on concertation at 150 °C is 2.5. The rate constant at 125 °C is 0.280 h and the equilibrium constant is 3.51. (a) What is the rate of R leaving the CSTR (mol/h)? (b) The flowrate to the PFR is increased so that the fractional conversion of A is 0.5 in the efluent from the CSTR. All other parameters remain unchanged. What is the new production rate of R?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)

Answers: 1

Answer

Engineering, 04.07.2019 18:20

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Plan an experiment to measure the surface tension of a liquid similar to water. if necessary, review the ncfmf video surface tension for ideas. which method would be most suitable for use in an undergraduate laboratory? what experimental precision could be expected?

Answers: 2

Answer

You know the right answer?

The homogeneous, reversible, exothermic, liquid phase reaction: A근R Is being carried out in a reacto...

Questions