Engineering, 21.02.2020 18:02 shatj960

A cuboid of Ge has contacts over all of its 2mm × 1 mm ends and point contacts approximately half way along its 5 mm length, at the centre of the 5 mm × 1 mm faces. A magnetic field can be applied parallel to this face. A current of 5 mA is passed between the end contacts when a voltage of 310 mV is applied. This generates a voltage across the point contacts of 3.2 mV with no magnetic field and 8.0 mV when a field of 0.16 T is applied.

ii. Using the corrected Hall voltage find the carrier density in the Ge sample.

iii. Estimate the conductivity of the Ge.

iv. What is the mobility of the carriers?

ANSWERS:

ii) 1.04e21 m^-3

iii) 40.3 s/m

iv) 0.24 m^2/V*s

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Air inially occupying a volume of 1 m2 at 100 kpa, 27 c undergoes three internally reversible processes in series. process 1-2 compression to 500 kpa during which pv constant process 2-3 adiabatic expanslon to 100 kpa process 3-1: constant-pressure expansion to 100 kpa (a) calculate the change of entropy for each of the three processes. (b) calculate the heat and work involved in each process. (c) is this cycle a power cycle or refrigeration cycle?

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Heat transfer by is the fastest mode of heat transfer that requires no intervening medium. a)-conduction b)-convection c)-radiation d)-conduction and convection

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?

Answers: 2

Answer

You know the right answer?

A cuboid of Ge has contacts over all of its 2mm × 1 mm ends and point contacts approximately half wa...

Questions