subject
Engineering, 24.02.2020 16:57 leysirivera23ovez6n

The velocity field of a flow is given by V = 30y/(x2 + y2)1/2i - 30x/(x2 + y2)1/2j ft/s, where x and y are in feet. Determine (a) the fluid speed at points along the x axis; (b) the fluid speed at points along the y axis. What is the angle between the velocity vector and the x axis (use the range (-180°; 180°]) at points (c) (x, y) = (2, 0); (d) (x, y) = (2, 2); (e) (x, y) = (0, 2)?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
question
Engineering, 04.07.2019 18:10
What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information
Answers: 3
question
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
You know the right answer?
The velocity field of a flow is given by V = 30y/(x2 + y2)1/2i - 30x/(x2 + y2)1/2j ft/s, where x and...
Questions
question
Mathematics, 06.10.2019 01:30
question
Mathematics, 06.10.2019 01:30
Questions on the website: 13722360