Engineering, 25.02.2020 02:33 yehnerthannah
A hole of diameter D = 0.25 m is drilled through the center of a solid block of square cross section with w = 1 m on a side. The hole is drilled along the length, l = 2 m, of the block, which has a thermal conductivity of k = 150 W/m·K. The four outer surfaces are exposed to ambient air, with T[infinity],2 = 25°C and h2 = 4 W/m2·K, while hot oil flowing through the hole is characterized by T[infinity],1 = 330°C and h1 = 50 W/m2·K. Determine the corresponding heat rate and surface temperatures.
Answers: 1
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
A hole of diameter D = 0.25 m is drilled through the center of a solid block of square cross section...
Biology, 18.02.2022 22:50
Geography, 18.02.2022 22:50
Computers and Technology, 18.02.2022 23:00
Mathematics, 18.02.2022 23:00
Computers and Technology, 18.02.2022 23:00
Mathematics, 18.02.2022 23:00