Engineering, 25.02.2020 17:53 Nickanderson21

A Diesel cycle engine is analyzed using the air standard method.
Given the conditions at state 1, compression ratio (r), and cutoff ratio (rc) determine the efficiency and other values listed below.
Note: The specific heat ratio and gas constant for air are given as k=1.4 and R=0.287 kJ/kg. K respectively.

T1 (K) = 328
P1 (kPa) = 190
r = 14
rp = 1.3
rc = 1.3

a) Determine the specific internal energy (kJ/kg) at state 1.
b) Determine the relative specific volume at state 1.
c) Determine the relative specific volume at state 2.
d) Determine the temperature (K) at state 2.
e) Determine the pressure (kPa) at state 2.
f) Determine the specific enthalpy (kJ/kg) at state 2.
g) Determine the temperature (K) at state 3.
h) Determine the pressure (kPa) at state 3.
i) Determine the specific enthalpy (kJ/kg) at state 3.
j) Determine the relative specific volume at state 3.
k) Determine the relative specific volume at state 4.
l) Determine the temperature (K) at state 4.
m) Determine the pressure (kPa) at state 4.
n) Determine the specific internal energy (kJ/kg) at state 4.
o) Determine the net work per cycle (kJ/kg) of the engine.
p) Determine the heat addition per cycle (kJ/kg) of the engine.
q) Determine the efficiency (%) of the engine.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Inadequate stores control is not an obstacle to effective work order system. (clo4) a)-true b)-false

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Inspection for bearing condition will include: (clo4) a)-color b)-smell c)-size d)-none of the above

Answers: 1

Answer

You know the right answer?

A Diesel cycle engine is analyzed using the air standard method.
Given the conditions at stat...