Engineering, 25.02.2020 21:22 seider8952
A full journal bearing has a journal diameter of 25 mm, with a unilateral tolerance of 20.03 mm. The bushing bore has a diameter of 25.03 mm and a unilateral tolerance of 0.04 mm. The lyd ratio is 1y2. The load is 1.2 kN and the journal runs at 1100 rev/min. If the average viscosity is 55 mPa ? s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
Engineering, 04.07.2019 18:20
Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms
Answers: 2
Engineering, 04.07.2019 18:20
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
You know the right answer?
A full journal bearing has a journal diameter of 25 mm, with a unilateral tolerance of 20.03 mm. The...
Questions
English, 05.05.2020 20:13
Social Studies, 05.05.2020 20:13
Mathematics, 05.05.2020 20:13
Biology, 05.05.2020 20:13
Social Studies, 05.05.2020 20:13
Engineering, 05.05.2020 20:13
Biology, 05.05.2020 20:13
Mathematics, 05.05.2020 20:13
Mathematics, 05.05.2020 20:13
