Engineering, 25.02.2020 23:19 zack66828

Tom and Judy like to use propane to heat a grill for summer barbeques. Starting with a mixture of propane (C3H8) and nitrogen (N2) that enters a condenser at 218 mol/min. The entering mixture is cooled in the condenser until a stream of pure liquid propane is produced. An exiting gas stream has a mole fraction of propane equal to 0.117 and the balance nitrogen. The liquid propane is recovered at a rate of 4.65 L/min. Liquid propane has a density of 0.493 g/cm3.

(a) Draw and label a process flow diagram. Clearly number each stream.

(b) Find the unknown molar flow rate (mol/min) and mole fractions.

(c) Calculate the mass fractions of the feed.

(d) If the exiting flow rate of liquid propane changed to 2.85 kg/min. Did the flow rate of the exiting gas stream increase, decrease or stay the same?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The higher the astm grain size number, the finer the gran is. a)-true b)-false

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed.gi) ifn 1, what will happen to the material when transformed material when

Answers: 1

Answer

Engineering, 04.07.2019 18:20

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

Answer

You know the right answer?

Tom and Judy like to use propane to heat a grill for summer barbeques. Starting with a mixture of pr...

Questions