Engineering, 25.02.2020 23:18 mvasquez3122p4vahv

A Dual cycle engine is analyzed using the cold air standard method. Given the conditions at state 1, compression ratio (r), and cutoff ratio (rc) determine the efficiency and other values listed below.
Note: The specific heat ratio and gas constant for air are given as k=1.4 and R=0.287 kJ/kg-K respectively.

--Given Values--
T1 (K) = 328
P1 (kPa) = 190
r = 14
rp = 1.3
rc = 1.3

a) Determine the specific internal energy (kJ/kg) at state 1.
b) Determine the temperature (K) at state 2.
c) Determine the pressure (kPa) at state 2.
d) Determine the specific internal energy (kJ/kg) at state 2.
e) Determine the temperature (K) at state 3.
f) Determine the pressure (kPa) at state 3.
g) Determine the specific internal energy (kJ/kg) at state 3.
h) Determine the specific enthalpy (kJ/kg) at state 3.
i) Determine the temperature (K) at state 4.
j) Determine the pressure (kPa) at state 4.
k) Determine the specific enthalpy (kJ/kg) at state 4.

l) Determine the temperature (K) at state 5.

m) Determine the pressure (kPa) at state 5.

n) Determine the specific internal energy (kJ/kg) at state 5.

o) Determine the net work per cycle (kJ/kg) of the engine.

p) Determine the heat addition per cycle (kJ/kg) of the engine.

q) Determine the efficiency (%) of the engine.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

When subject to a steady load (within elastic range) over a long period of time, what is the major difference in material behavoir between steel and plastic?

Answers: 2

Answer

Engineering, 04.07.2019 19:10

A)-explain briefly the importance of standards in engineering design. b)- what is patent? c)-explain the relationship between these standards: b.s. and b.s.en d)- in engineering design concepts, types of loads and how they act are important factors. explain.

Answers: 3

Answer

You know the right answer?

A Dual cycle engine is analyzed using the cold air standard method. Given the conditions at state 1,...

Questions