subject
Engineering, 26.02.2020 00:10 wrightdarius78

The state of stress at a point is σx = 17 kpsi, σy = 0 kpsi, σz = 17 kpsi, τxy = 34 kpsi, τyz = -31 kpsi, and τzx = 0 kpsi.
Determine the principal stresses.
The principal normal stress σ1 is determined to be kpsi.
The principal normal stress σ2 is determined to be kpsi.
The principal normal stress σ3 is determined to be kpsi.
The principal shear stress τ1/2 is determined to be kpsi.
The principal shear stress τ2/3 is determined to be kpsi.
The principal shear stress τ1/3 is determined to be kpsi.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 14:10
Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.
Answers: 2
question
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
question
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
question
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
You know the right answer?
The state of stress at a point is σx = 17 kpsi, σy = 0 kpsi, σz = 17 kpsi, τxy = 34 kpsi, τyz = -31...
Questions
question
Mathematics, 13.05.2021 19:40
Questions on the website: 13722367