Engineering, 26.02.2020 05:21 jtroutt74

A 50 kbps satellite channel is used to transmit 1000-bit frames between Sophie in Moscow and Richard in New York. Assume that the distance between Richard and the satellite and the distance between the satellite and Sophie are the same, which is approximately 36; 000 km. The satellite acts as a transponder (a repeater). Assume that the processing time at transmitter, satellite and receiver, and the transmission time for the acknowledgment frame are all negligible. Due to the good error correction code in the frame, you could assume that the channel error rate is negligible. We de ne channel efficiency as:

(x frame transmission times)/ (total time spent for transmitting x frames) ,

where x can be any positive integer. The speed of light is 3x 10^8 meter per second.

a. If the Stop and Wait ARQ Protocol is used, what is the channel efficiency?
b. If the sliding window ARQ protocol is used with receiving window size equal to 1, the sequence number field in the frame is 3 bits long, what is the channel efficiency if the maximum sending window size is used?
c. If the sliding window ARQ protocol is used with receiving window size equal to sending window size, the sequence number field in the frame is 3 bits long, what is the channel efficiency if the maximum sending window size is used?
d. If the sequence number field in the frame is 8 bits long, answer (b) and (c).

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information

Answers: 3

Answer

Engineering, 04.07.2019 18:20

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

Answer

You know the right answer?

A 50 kbps satellite channel is used to transmit 1000-bit frames between Sophie in Moscow and Richard...

Questions