subject
Engineering, 26.02.2020 18:05 Tyrant4life

A heat pump (working in a thermodynamic cycle mode) is to be used to heat a house during the winter. The house is to be maintained at 294 K at all times. The house is estimated to be losing heat at a rate of 135,000 kJ/h when the outside temperature drops to 268 K. If the heat pump under these conditions has a coefficient of performance of 4, (a) Determine the power required to drive this heat pump (b) Determine the rate at which heat is absorbed from the cold outdoor air Repeat the questions assuming the heat pump works in a reversible mode. You need to calculate the coefficient of performance under these conditions.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false
Answers: 1
question
Engineering, 04.07.2019 18:10
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
You know the right answer?
A heat pump (working in a thermodynamic cycle mode) is to be used to heat a house during the winter....
Questions
question
English, 01.10.2019 16:40
Questions on the website: 13722362