subject
Engineering, 26.02.2020 17:37 sindy35111

While discussing electrical relays: Technician A says that the relay's coil is energized when the circuit's control switch is open. This action connects power to the load circuit. Technician B says that a relay is an electric switch that allows a large amount of current to control a low-current circuit. Who is correct?a. Technician A b. Technician Bc. Both A and Bd. Neither A nor B

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
question
Engineering, 04.07.2019 18:10
Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?
Answers: 3
question
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
You know the right answer?
While discussing electrical relays: Technician A says that the relay's coil is energized when the ci...
Questions
question
Computers and Technology, 17.12.2019 20:31
question
Mathematics, 17.12.2019 20:31
question
Mathematics, 17.12.2019 20:31
Questions on the website: 13722361