subject
Engineering, 27.02.2020 00:15 danielmartinez024m

In "Rabbitville", the rabbit population squares each year. e. g. If you start with 4 rabbits, you'll have 16 in 1 year, and 256 in 2 years. Once the population exceeds 10,000 bunnies, food will be scarce, and population will begin to decrease.

Write a function years_till_no_carrots that includes a WHILE loop. Given a single integer (# of starting rabbits) as an input, your function should output the number of whole years until the number of rabbits becomes larger than 10000. e. g. years_till_no_carrots(4) = 3 (start with 4 rabbits, population greather than 10000 & food scarce in 3 years)

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
You know the right answer?
In "Rabbitville", the rabbit population squares each year. e. g. If you start with 4 rabbits, you'll...
Questions
question
Mathematics, 12.02.2021 22:10
question
Mathematics, 12.02.2021 22:10
question
Mathematics, 12.02.2021 22:10
Questions on the website: 13722359