subject
Engineering, 27.02.2020 04:53 nayelycuencax

You get invited to a party at a 1,200 sf apartment, where there are a total of 23 people. The apartment has ceilings that are 8 ft above the floor. Three people begin smoking 2 cigarettes per hour each. The air handler system has a make-up air ventilation rate of 600 cfm. Assume an overhead fan ensures the air is well-mixed. Eye irritation from formaldehyde can start at concentrations of 0.01 ppm, with irritation of the lungs at 5 ppm. Will the concentrations become high enough to cause eye irritation

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k
Answers: 2
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
question
Engineering, 04.07.2019 18:20
Inadequate stores control is not an obstacle to effective work order system. (clo4) a)-true b)-false
Answers: 3
You know the right answer?
You get invited to a party at a 1,200 sf apartment, where there are a total of 23 people. The apartm...
Questions
question
Mathematics, 10.12.2020 08:20
question
Mathematics, 10.12.2020 08:20
question
Mathematics, 10.12.2020 08:20
question
Mathematics, 10.12.2020 08:20
question
Mathematics, 10.12.2020 08:20
question
Mathematics, 10.12.2020 08:20
question
History, 10.12.2020 08:20
question
Mathematics, 10.12.2020 08:20
Questions on the website: 13722367