subject
Engineering, 02.03.2020 19:46 gamblenyny

4. 1 atm air flows at 7.5 m/s over a 1.5 m x 6 m flat plate. Air temperature is 20oC and the plate temperature is 140oC. Determine the rate of heat transfer from the plate if the air flows parallel to the 1.5 m side. If the leading edge of 0.2 m is insulated, determine the rate again and compare the two cases

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
question
Engineering, 04.07.2019 19:20
In the winter, in order to keep the classroom steadily at 68 f before 10 pm, heating with an average rate of 42,000 btu/hr is provided. assume the outdoor temperature maintains at 32°f, determine the electrical power (kw) required to (a) operate a reversible heat pump (b) operate a real heat pump with a cop (7) of 4.5 and (c) operate an electrical-resistance heater.
Answers: 3
question
Engineering, 06.07.2019 03:20
An air-conditioning system consists of a heating section and an evaporative cooler. air enters the heating section at 10°c and 70 percent relative humidity at a rate of 30m^3/min, and it leaves the evaporative cooler at 20°c and 60 percent relatively humidity. if the air conditioning system operates at a total pressure of 98 kpa, determine (a) the temperature and relative humidity of the air when it leaves the heating section, (b) the rate of heat transfer in the heating section, and (c) the rate of water added to air in the evaporative cooler
Answers: 2
question
Engineering, 06.07.2019 05:10
The crank case of an automobile is 80 cm long 30 cm wide and 10 cm deep. find out the rate of heat flow from the crank case to the atmosphere when the automobile is moving at 90 km/hr. assume that the vibration of the engine and the chassis iaduce the transition from laminar to turbulent boundary layer may be considered over the entire surface. also find out the drag force on the total surface of the crank case. take the same average convective heat transfer coefficient and average shear stress for front and rare surfaces as for the bottom rnd sides crank case surface temperature is 75°c and atmospheric air temperature is 5 c
Answers: 2
You know the right answer?
4. 1 atm air flows at 7.5 m/s over a 1.5 m x 6 m flat plate. Air temperature is 20oC and the plate t...
Questions
Questions on the website: 13722360