Engineering, 03.03.2020 02:05 Esmail
An op-amp with a gain bandwidth product (GBP) of 1 MHz is used to construct a non-inverting amplifier. If the desired bandwidth of the amplifier is 13 kHz, what is the maximum allowable gain of the non-inverting amplifier? (Your answer should be accurate to within +/- 0.1)
Answers: 2
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:20
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
Engineering, 04.07.2019 19:20
Aseries piping system conveys methyl alcohol. the system consists of 70 m of 1- nominal pipe follow by 50 m of 2-nominal pipe, both schedule 40 commercial steel. the 1-nominal pipe contains 3 90Β° elbows (regular) anda fully open gate valve, all threaded. the pressure drop through the system is 150 kpa. determine the volume flow rate through the system that is horizontally laid.
Answers: 1
Engineering, 04.07.2019 19:20
To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160Β°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.
Answers: 1
An op-amp with a gain bandwidth product (GBP) of 1 MHz is used to construct a non-inverting amplifie...
Mathematics, 31.10.2020 19:10
Mathematics, 31.10.2020 19:10
Mathematics, 31.10.2020 19:10
Business, 31.10.2020 19:10
French, 31.10.2020 19:10
Mathematics, 31.10.2020 19:10
Biology, 31.10.2020 19:10
Mathematics, 31.10.2020 19:10
English, 31.10.2020 19:10
Biology, 31.10.2020 19:10