Engineering, 03.03.2020 04:31 davidebner2248

You are to design a digital communication system to transmit four multiplexed analog signals with bandwidths of 1200 Hz, 900 Hz, 300 Hz and 1500 Hz, respectively. Each analog signal is to be sampled at its own respective Nyquist rates and encoded using linear PCM. The maximum tolerable error for each sample is 1% of the signal's peak voltage (Vo).
(a) What is the minimum PCM word size (bits per sample) required?
(b) What is the minimum transmitted bit rate for each of the sampled signals?
(c) Assume the signals are multiplexed on a sample-by-sample basis (each PCM sample is considered a unit not to be divided between frames). If 10 bits per frame are added for synchronization, what is the minimum frame size required (bits)? How many samples from each signal are included in each frame?
(d) What is the transmitted frame rate of the frame defined in part (c) in frames per second? What is the overall transmitted bit rate of the multiplexed digital communication system (bits per second)?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

Answer

You know the right answer?

You are to design a digital communication system to transmit four multiplexed analog signals with ba...

Questions