Engineering, 04.03.2020 03:04 johny144

A solid titanium alloy [G 114 GPa] shaft that is 720 mm long will be subjected to a pure torque of T 155 N m. Determine the minimum diameter required if the shear stress must not exceed 150 MPa and the angle of twist must not exceed 7?. Report both the maximum shear stress ? and the angle of twist ? at this minimum diameter. ?Part 1 where d is the shaft diameter. The polar moment of inertia is also a function of d. Find Incorrect. Consider the elastic tors on formula. The maximum shear stress occurs at the radial location ? = (d 2 the value of d for which the maximum shear stress in the shaft equals 150 MPa. Based only on the requirement that the shear stress must not exceed 150 MPa, what is the minimum diameter of the shaft? dr 16.1763 the tolerance is +/-2% Click if you would like to Show Work for this question: Open Show Work Attempts: 1 of 3 used SAVE FOR LATER SUBMIT ANSWER Part 2 Based only on the requirement that the angle of twist must not exceed 7°, what is the minimum diameter of the shaft?

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

Answer

You know the right answer?

A solid titanium alloy [G 114 GPa] shaft that is 720 mm long will be subjected to a pure torque of T...

Questions