Engineering, 04.03.2020 23:46 tyaniahawarren

If you haven’t already done so, enter the commands in the example above to generate the permutation matrix E defined in (2) (you can suppress this matrix). Generate a 5 × 5 matrix A with integer entries using the command A = floor(10*rand(5))

(a) Compute the product EA and compare the answer with the matrix A. How are the two matrices related? Describe the effect on A of left multiplication by the permutation matrix E. Be specific! Compute the product AE and compare the answer with the matrix A. How are the two matrices related? Describe the effect on A of right multiplication by the permutation matrix E. Be specific!

(b) Compute E−1 and ET (recall that ET is computed in MATLAB with the command E’), and observe that they are also permutation matrices. What else do you observe about E−1 and ET ?

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables

Answers: 1

Answer

Engineering, 04.07.2019 18:10

What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

If you haven’t already done so, enter the commands in the example above to generate the permutation...

Questions