Automata de pila
Realice de manera detallada y grafica el procedimiento paso a paso del...
Engineering, 05.03.2020 00:09 tfraz4412
Automata de pila
Realice de manera detallada y grafica el procedimiento paso a paso del recorrido de una cadena (La cadena la selecciona el estudiante, debe contener como mínimo 8 caracteres) en el autómata a pila. Describir cómo funciona el almacenamiento en la pila, como funciona LIFO, etc.
Answers: 2
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:20
Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]
Answers: 1
Spanish, 24.10.2020 03:20
Mathematics, 24.10.2020 03:20
Mathematics, 24.10.2020 03:20
Mathematics, 24.10.2020 03:20
Mathematics, 24.10.2020 03:20
English, 24.10.2020 03:20
Biology, 24.10.2020 03:20
Mathematics, 24.10.2020 03:20
Mathematics, 24.10.2020 03:20
Mathematics, 24.10.2020 03:20