Engineering, 06.03.2020 22:38 potatoismeh1
The total solidification times of three casting shapes are to be compared: (a) a sphere with diameter = 10 cm, (2) a cylinder with diameter and length both = 10 cm and (3) a cube with each side = 10 cm. The same casting alloy is used in the three cases. (a) Determine the relative solidification time for each geometry. (b) Based on the results of part (a), which geometric element would make the best riser? (c) If Cm = 3.5 min/cm2 in Chvorinov’s Rule, compute the total solidification time for each casting.
Answers: 3
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
The total solidification times of three casting shapes are to be compared: (a) a sphere with diamete...
Business, 23.06.2019 22:50
Geography, 23.06.2019 22:50
Biology, 23.06.2019 22:50
Mathematics, 23.06.2019 22:50
Biology, 23.06.2019 22:50
Mathematics, 23.06.2019 22:50
Mathematics, 23.06.2019 22:50
Mathematics, 23.06.2019 22:50