Engineering, 07.03.2020 00:18 shan8747

Assuming D=0.6, determine the ratio Vo/Vin QUESTION 7 In the previous question, determine IL/Io. QUESTION 8 Determine the RMS value of the following waveform (first do something about the second and 3rd terms). v(t) = 3 + 10cos(wt) + 5 sin(wt) + 4 cos(3wt) + 2sin(7wt-30) QUESTION 9 Consider the following signal: Starts at the origin. Linearly decreases to -1 by T/6. Remains at -1 until T/3. Then linearly increases to 1 by 2T/3. Remains at 1 for another T/6, and then decreases linearly to 0 at T. T is the period. Solve for a0 QUESTION 10 For the previous question, solve for a5 QUESTION 11 From Question 9, solve for b5. QUESTION 12 From Question 9, solve the RMS value of the fundamental component.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

Answer

You know the right answer?

Assuming D=0.6, determine the ratio Vo/Vin QUESTION 7 In the previous question, determine IL/Io. QUE...

Questions