Engineering, 07.03.2020 01:44 Edwardwall

A laminate [60/45/0/45] is prepared using AS/3501 graphite-epoxy lamina. The material properties for the AS/3501 graphite epoxy lamina are: E- 140 GPa E2 23-10 GPa V12=V13 = 0.3 V23 0.3 G12= G13 = 7 GPa Xy = 400MPa Xc--300MPa Yr 400 MPa ??-:-300 MPa S=70MPa

a) Assuming each lamina thickness is 1 mm, calculate A, BI and DI for the laminate.
b) A beam AB of 100 mm length and 20 mm width is fabricated using the above AS/3501 graphite- epoxy [60/45/0/45] laminate. The beam AB is subjected to only a pure bending moment M. Using the maximum stress theory; predict the maximum allowable value of the M.
c) For the beam AB, predict the maximum allowable value of M using Tsai-Wu Hill.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Answers: 1

Answer

Engineering, 03.07.2019 14:10

When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point

Answers: 3

Answer

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

You know the right answer?

A laminate [60/45/0/45] is prepared using AS/3501 graphite-epoxy lamina. The material properties for...

Questions