Engineering, 07.03.2020 02:59 pilararcos

Problem 4 You are designing a circuit to drive LED1, using the following circuit. The datasheet for the LED specifies that VF = 2 V. Treat LEDs as diodes with the constant voltage model. (a) Find the expected current through the LED I(LED) when VF = 2 V (b) After testing, it is determined that some LEDs within a batch do not light up correctly in the circuit for part a. It is suspected that this is because there is some variation in among the LEDs in the batch. Find the maximum value of VF such that the circuit above stops working I(LED) drops to zero so you can characterize this problem and report it to the manufacturer.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Aheavily insulated piston-cylinder device contains 0.02 m3 of steam at 300 kpa and 200 °c. 1.2 mpa. d this process. team is now compressed in a reversible manner to a pressure of etermine the entropy change and the work done on the steam during this process

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Agas contained within a piston-cylinder assembly e end nation about same energy states, 1 and 2, where pi 10 bar, v undergoes two processes, a and b, between the sam 0.1 m3, ui-400 kj and p2 1 bar, v2 1.0 m2, u2 200 kj: process a: process from 1 to 2 during which the pressure- volume relation is pv constant process b: constant-volume process from state 1 to a pressure of 2 bar, followed by a linear pressure-volume process to +20 0 state 2 kinetic and potential energy effects can be ignored. for each of the processes a and b, (a) sketch the process on p-v coordinates, (b) evaluate the work, in kj, and (c) evaluate process the heat transfer, in kj

Answers: 2

Answer

Engineering, 04.07.2019 19:20

To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.

Answers: 1

Answer

You know the right answer?

Problem 4 You are designing a circuit to drive LED1, using the following circuit. The datasheet for...

Questions