subject
Engineering, 09.03.2020 23:56 jalst6084

Air enters a horizontal, constant-diameter heating duct operating at steady state at 290 K, 1 bar, with a volumetric flow rate of 0.25 m3/s, and exits at 325 K, 0.95 bar. The flow area is 0.04 m2. Assuming the ideal gas model with k 5 1.4 for the air, determine:

(a) the mass flow rate, in kg/s,
(b) the velocity at the inlet and exit, each in m/s, and
(c) the rate of heat transfer, in kW.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
question
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
question
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
question
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
You know the right answer?
Air enters a horizontal, constant-diameter heating duct operating at steady state at 290 K, 1 bar, w...
Questions
question
Biology, 25.03.2021 20:40
question
Mathematics, 25.03.2021 20:40
question
Advanced Placement (AP), 25.03.2021 20:40
question
Mathematics, 25.03.2021 20:40
Questions on the website: 13722361