subject
Engineering, 10.03.2020 20:37 cloeybrown

Your fellow subsea engineer finally returns from her honeymoon dive trip, all tan and rested, talking incessantly about how great it was, etc. etc. While everyone is getting back up to speed on the subsea equipment and recent developments, you are notified that your pipeline permit documentation is not complete for the Red Hawk flowline for GB 877 Well 1 and you need to get the missing information to authorities right away, but the pipeline design company representative is not available.1) What information do you have and/or can be deduced about the Red Hawk flowline? Be as detailed as possible.2) From the information identified, specify what kind of pipeline it is, what the jurisdiction is and the associated permitting requirements?

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
question
Engineering, 04.07.2019 18:10
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
question
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
question
Engineering, 04.07.2019 19:10
10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.
Answers: 2
You know the right answer?
Your fellow subsea engineer finally returns from her honeymoon dive trip, all tan and rested, talkin...
Questions
question
Mathematics, 30.03.2021 16:40
question
Mathematics, 30.03.2021 16:40
Questions on the website: 13722363